Rick 2.0's Recent Activity
-
Rick 2.0 replied to the thread Workbee Lead 1000x1000 Wheel Clearance too tight.
If you’re getting 8.6mm it sounds like your bearings are not properly seated. This is one of those items that is very consistent. A...
Jun 5, 2024 at 9:14 AM -
Rick 2.0 replied to the thread OpenBuilds Table Series.
4x4s and 2x8s would probably be your best bet.
Jun 4, 2024 at 9:14 PM -
Rick 2.0 replied to the thread Workbee Lead 1000x1000 Wheel Clearance too tight.
Yes. And if in doubt this is fairly easy to check with digital calipers. Set the wheels in place and measure between the inside edges of...
Jun 4, 2024 at 7:47 PM -
Rick 2.0 replied to the thread Workbee Lead 1000x1000 Wheel Clearance too tight.
It is and this can be found in a number of threads over the years, most of them 8-10 years ago. There were a lot of problems with...
Jun 4, 2024 at 12:43 PM